Remove the gear motor brushless controller to put out the light to take light, don't foolhardy, also need to pay attention to the following points: a. The motor controller external wiring removed first, at the same time pay attention to the marking, after the foot screw loosening, and separating the motor controller and mechanical transmission. b。 When removing the pulley shaft above the motor controller and coupling, sometimes need to add some kerosene in the gaps between the pulley shaft motor controller, so that we can make its permeability lubrication in place, we remove the convenience. c。 Contain some rolling bearings of motor controller, we need to remove the bearing cover, and then again in the fastening screw to loosen the end cover, in the end cover and base shell seams of mark, and then unloaded tighten screw into the motor end cover of the controller is set on the end cover of two screw hole, and then the top end cover. d。 When removing the motor controller with a brush, should have a brush from the brush to remove, to go to dc motor controller, even will brush make on mark the location of the neutral line e. When we take out the rotor, it is important to note that don't touch wound stator winding, rotor is not heavy, you can go out with the hand, heavier haha, lifting equipment should be used to hang out, not artificial, or prone to accidents or damage to, at this time of the first will be set on both ends of the rotor shaft to the reuse of wire rope the rotor with lifting equipment. Take out slowly.
