Removere calces motor Brushless moderatoris ut extinguetur lumen ad lucem, non Stolhardy, etiam opus ad attendere ad haec puncta: A. Motor controller externa wiring remota prima simul attendere ad vestigium post pedem screw laxitas et separans motor moderatoris mechanica tradenda. b。 When removing the pulley shaft above the motor controller and coupling, sometimes need to add some kerosene in the gaps between the pulley shaft motor controller, so that we can make its permeability lubrication in place, we remove the convenience. c。 Contain some rolling bearings of motor controller, we need to remove the bearing cover, and then again in the fastening screw to loosen the end cover, in the end cover and base shell seams of mark, and then unloaded tighten screw into the motor end cover of the controller is set on the end cover of two screw hole, and then the top end cover. d. Cum removendo motricium moderatoris cum penicillo, debet habere penicillo a peniculus ad removendum, ut ad DC motricium moderatoris, etiam peniculus facere in marcam locum neutrum linea e. When we take out the rotor, it is important to note that don't touch wound stator winding, rotor is not heavy, you can go out with the hand, heavier haha, lifting equipment should be used to hang out, not artificial, or prone to accidents or damage to, at this time of the first will be set on both ends of the rotor shaft to the reuse of wire rope the rotor with lifting equipment. Eximito tardius.
