In the family of reducer, planetary reduction step motor with its small size, high transmission efficiency, speed range is wide, many a little bit higher accuracy, and is widely used in step, step by step, such as dc transmission system. Its role is on the premise of guarantee precision transmission, mainly used to reduce speed increase torque and lower than the rotational inertia of the load/motor. in the past few years, some users in the use of deceleration machine, due to human factors, such as illegal installation and lead to the output shaft of the reducer is broken, make the enterprise have suffered unnecessary loss. Therefore, in order to better help the masses of users with good speed reducer, four macro motor to you detail how to correctly install planetary reducer. the correct installation, use and maintenance of the reducer, ensure the normal operation of machinery and equipment is the important link. Therefore, in machine of decelerate of planet of installation, please be sure to use related matters in strict accordance with the following installation, assembly and use seriously. the first step: before installation, make sure the motor and speed reducer are intact, and strict inspection of motor and reducer connected parts size matches, here is the positioning convex sets, input shaft of the motor and reducer groove size and tolerance, etc. step 2: unscrew the reducer flange lateral dust hole on the screw, adjust the PCS system clamping ring side holes aligned with the dust holes, insert the socket head screw. After taking the motor shaft key. step 3: connect the stepper motor and speed reducer nature. Connection must ensure that the reducer output shaft and motor input shaft concentricity is consistent, and the two parallel to the outer flange. Such as concentricity inconsistent, can lead to broken motor shaft or reducer gear wear and tear. in addition, when installation, it is forbidden to use the hammer hit, such as prevent damage of axial force and radial force is too large bearings or gears. Must will be installed after the bolt tightening bolt screw tight force again. Before installation, the motor input shaft, the positioning convex sets and rust-proof oil of the reducer connection with gasoline or zinc sodium water wipe clean. Its purpose is to guarantee the tightness of the connection and operation flexibility, and prevent unnecessary wear and tear. in front of the motor and the reducer connection, should first will bolt vertical motor shaft keyway and force. In order to ensure the uniform stress, first to the installation of the bolt screw on arbitrary diagonal position, but do not tighten, then screw in the installation of the other two diagonal position bolt finally tighten the four mounting bolts one by one. Finally, the bolt screw tight force. All bolts must be torque wrench tight force according to the fixed torque data indicated by the fixed and check. the proper speed reducer and mechanical equipment installation similar reduction between the stepper motor and drive motor installed correctly. The key is to must ensure that the part reducer output shaft and driven shaft concentricity. the main products: stepper motor, brushless motor, servo motor, stepping motor drive, brake motor, linear motor and other kinds of models of the stepper motor, welcome to inquire. Telephone:
