1 motor is fixed at the bottom of the hole to hole, the M4 thread, effective teeth for 7 mm long, combined with the length of 6 mm. According to the installed base plate and screw of different need to choose a different location, in order to install tighten completely.
such as mounting base for 3 mm thick, then screw the minimum specifications for the M4 * 9, because there is no the screw, so the smallest screw for M4 * 10 or M4 * 12.
2 motor front cover screw into the depth of 8. 0 mm, normal depth is 6 mm, M3 thread, according to the different thickness of propeller (If installed directly propeller), use different screw, straight blade more tablet thickness of 2. Between 5 mm.
for example: screw thickness of 6 mm, so the length of the mounting screw to 2. 5 mm 6 mm 6 mm, the screw specification for M3 * 14. 5 mm, it is recommended to use screw M3 * 15 mm.
3 motor wire position need to have the corresponding vacancies,, lest crushed, cause a short circuit accident, exact location of the gap, please refer to the figure shape or in kind prevail.
motor debugging
1 for debugging, please do not install the propeller. To motor, electric adjustment, speed control system is completed, nudging the throttle, motor operation, observe the motor running condition, to determine whether the motor running, whether running smoothly.
2 use 12 s (Nominal 44. 4V）Battery test, full throttle operation, detection of busbar current, because the battery is different, there will be a certain difference, the full charge no more than 1. 8 a, after normal operation according to the results of the temperature measurement and the corresponding technical specification, confirm the motor is normal. brushless motor
