Committed to the development and manufacturing of high-quality high-voltage brushless motors and controllers.

Why planetary reduction opportunities appear broken shaft imagination

by:Hoprio     2020-07-22

why planetary reduction opportunities appear broken shaft to imagine. First appear broken shaft may be of the biggest problems is the planet reducer is a problem with the quality. Of course this is our normal person can think of, one of the main reasons is the usual use process reasons. Such as in the use of machine of decelerate of planet of the process of acceleration and deceleration and what should we pay attention to, have what good method. Below is the reducer summarizes three causes Shanghai language. One, some applications must strictly abide by the code, this is not only the protection of reducer, more major is to avoid the planet reducer output shaft was broken. This is mainly because, if there is something wrong with the equipment installation, reducer output shaft and the load was stuck, then drive motor controller of the overload capacity will continue to make its increasing output, in turn, is likely to make the output of the reducer bearing force by more than 2 times of its rated output torque and twist off the output shaft of the reducer. Second, in the process of acceleration and planetary reducer reducer, planetary reducer output shaft by the instantaneous torque if more than 2 times of its rated output torque, and the acceleration and deceleration and too often, that will eventually make the reducer shaft broken. Considering the problem of less, so there is no longer a further introduction. Three, the wrong selection caused by reducer output was not enough. Some users in the selection, mistakenly believe that as long as the selected machine of decelerate of planet of rated output torque can meet the job requirements, actually otherwise, one is the rated output torque motor controller by worthy of reduction ratio, the value in principle than the similar product samples provided by the rated output torque of the speed reducer, the second is should also consider the overload capacity of the drive motor controller and the largest in actual work torque. In theory, the user needs to maximum torque. Must be less than 2 times of reducer rated output torque. Among them in the use of machine of decelerate of planet of must pay attention to its code of conduct, as well as the wrong selection for deadly efforts not enough reasons. Problem broken shaft reducer output is too small, the machine of decelerate of planet of broken axis is a common problem. In addition because of bad reducer output assembly concentricity of speed reducer shaft broken away. The above three points is the reasons and problems that may occur. http://www。 tcmotor。 Com foshan electrical and mechanical equipment co. , LTD. , brushless motor controller, brushless dc motor controller, dc servo motor controller, planetary reducer, brushless drive, electrical and mechanical, foshan electrical and mechanical equipment co. , LTD
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...