1 servo motor controller of oil and water protection. Servo motor controller can be used in the places where water or oil droplets hit, but it is not a full waterproof or oil. Therefore, servo motor controller should not be placed or used in the water or oil immersion environment. If the servo motor controller is connected to the reduction gear, the use of servo motor controller should be oil seal, in order to prevent the oil into the gear, the servo motor controller cable don't immersed in oil or water. 2 servo motor controller cable to reduce stress. To ensure that the cable is not because of external bending force or under vertical load torque or its weight, especially in the cable or joint at the exit. Under the condition of the servo motor controller to move, should put the cable (With the motor controller configuration)Firmly fixed to a stationary part (Relative motor controller)And should be with an additional cable installed in the cable support to prolong it, so that the bending stress can be reduced to small, the bend radius of the cable as large as possible. 3 servo motor controller allows the shaft end of load. Take special care when installing a rigid coupling, especially the excessive bending load may cause the damage of the shaft end and bearing or wear and tear. The use of flexible coupling, so that the radial load is lower than the allowable values, it is designed for high mechanical strength of the servo motor controller design. In the installation, remove the coupling shaft end parts to the servo motor controller, do not drum shaft end (directly with the hammerHammer banging on shaft end directly, servo motor controller on the other end of the shaft encoder to knocked bad)。 To better align the shaft end to the state (For not neat, may lead to vibration or bearing damage)。
