brushless dc gear motor controller installation and usage brushless dc gear motor controller with high service life and good controllability, low noise, high speed advantages, has been widely used in many control areas. But have to use reducer in many occasions, such as the need to low output speed, to get the speed of the motor controller is lower than 1000 turn, generally need to use reducer. Another case is need high output torque, rely on the torque of the motor controller itself is limited, when equipment are in need of high torque, you need to use the reducer to increase torque. Reducer is key to the effect of the brushless dc motor controller, if reducer is bad, will also affect the use effect of the brushless dc gear motor controller. Brushless dc gear motor controller installation and instructions are as follows: 1, the brushless dc motor controller is usually 3 -5 wire, positive and negative level cannot meet the, meet the will burn machine; 2, brushless motor controller cannot run overload for a long time, otherwise easy to burn machine; 3, brushless motor controller for precision electronic components, not violent collisions; 4, the speed of brushless dc motor controller by PWM speed regulating, rather than through the voltage control of motor speed, usually of the brushless dc motor controller voltage is constant. Brushless dc gear motor controller of gear box installation and instructions are as follows: 1, if you want to change the brushless dc motor speed controller installation location, to the corresponding correct lubricating oil filling quantity. 2, when using brushless dc gear motor controller must abide by the provisions of the manual on, in strict accordance with the said on the manual operation; 3, brushless dc gear motor controller in use process in the corresponding standards and procedures within the scope of work, must not beyond. 4, upon receipt of the product to check in time is damaged during transit, or the lack of parts, etc. , if there is a problem please contact logistics or manufacturer. 5, all with the transportation, installation, commissioning, operation, maintenance and repair work, there can only be related operations professionals in accordance with the relevant provisions. Invalid 6, brushless dc gear motor, controller, enclosure, gear, shaft and bearing according to scrap processing. Part of the turbine is non-ferrous metal manufacturing, according to the environmental protection regulations, to correctly the collection and handling of the oil. 7, if in brushless dc gear motor controller using incorrect appeared in the process of installation and use, installation, and operation behavior is not correct, not to install or dismantle protective cover and cover the behavior, will likely result in serious injuries and property losses. In brushless dc gear motor controller in use process found abnormal reduction motor controller, it is necessary to stop the machine immediately to check and make sure reasons: 1, the brushless dc motor speed controller had better be to adopt soft start, try to avoid full launch. 2, check the brushless dc gear motor with no load controller steering direction should correctly, can monitor running sound is normal. 3, the requirements of the lubricating oil: brushless dc gear motor controller meets the requirements of lubricating oil will be listed before use. At the same time before work should check whether the oil amount is suitable. 4, brushless dc gear motor controller in the first run for the first time or after major repair replacement parts must be in the formal work of no-load running, running in and time shall not be less than 24 h. 5, boot after careful observation of the brushless dc gear motor controller sealing, noise, vibration, temperature rise of situation is normal, if malfunction should immediately stop, find out the reasons, troubleshooting rear can continue to use. 6, brushless dc gear motor, controller should take proper amount of lubricating oil lubrication in front of the boot shaft bearing.
