Shanghai four macros below the stepper motor will explain in detail to the zero calibration method, mainly include: 1, the direct zero method. The way to device an end stop at zero, and then make the stepper motor drive in the direction of zero point of view, big enough when step motor back to zero, is blocked by stop, motor suspension bearing is zero. The zero method is simple, but when the motor is stop block, still drives the motor performance of zero, thus not only on the stepper motor and transmission mechanism, formation damage will happen severe vibration and large noise. 2, sensor method. The way device at zero hall switch, photoelectric diode, such as position sensor, when the stepper motor back to zero, the sensor signal is given, the control circuit detects the signal, the motor stops in the zero position. The zero method are accurate and reliable, but increased the complexity of the circuit, is must demand for device. 3, choose belt stalling testing dedicated motor driver chip. The chip when the motor stalling, can immediately detect the motor stalling, and then determine the zero position. But the way poor universality, for stepping motor's winding current phase must demand, and this method cannot be used under the microstep driving method. The above content for Shanghai four macros stepper motor encountered in the practical work of doubt to pack, for reference, if you have any questions please timely communication, correct. the main products: stepper motor, brushless motor, servo motor, stepping motor drive, brake motor, linear motor and other kinds of models of the stepper motor, welcome to inquire. Telephone:
