Stepper motor in the process of using, if workers do not pay attention to, is prone to problems. The stepper motor in the process of using appear what problem? The following simple and everybody said. And help you to solve these problems. One, the motor in the process of operation, its core will be loose. Motor shall be stopped, then staff use tools to tighten iron core. If can not use the stator core, this time will be replaced in a timely manner, so as not to affect the later use. Second, the winding cable tie fracture, insulation. This is mainly because Lord motor in the process of use, can appear abnormal vibration, this will lead to the emergence of the phenomenon. This time will be to replace it. Three, the motor winding joint fracture and charred. The reasons for this phenomenon may be because the motor itself quality problems, and then high load operation. As a result, this also is it at work, these symptoms. So when buying a stepper motor, it is good to must choose quality motor. Four, stepper motor brush slip ring to loosen, by this time also motor must be stopped, then tighten the reinforcement. So, the staff at work, if it is found that motor fault, the above several machine motor must be stopped for repair, that is to ensure that it will not affect other artifacts, and also can reduce the cost of maintenance, to prevent potential safety hazard. the main products: stepper motor, brushless motor, servo motor, stepping motor drive, brake motor, linear motor and other kinds of models of the stepper motor, welcome to inquire. Telephone:
