The use of stepper motor is limited by the temperature and humidity of the work site, the use place not only in the room. OA machines are used for indoor environment good place, step motor using the environment in a sealing state; But when used in automobiles and FA machines, also in a dusty environment; Or placed outside the machine,Monitor, etc. ); Or use in high temperature environment. Stepper motor manufacturers have instructions on the standard model in the sample. If you want to special order should bargain with the manufacturer. 1, environmental temperature, the insulation of the stepper motor and so on more polar E motor. E using the environment temperature is 500 c, under 70 ℃, the temperature of the motor coil temperature shall not exceed 1200 c. Stepper motor actual installation, usually installed in a metal base plate or outside wall. The installation of step motor can have the function of the heat sink, metal box is smaller than when motor separately measured temperature rise. Temperature control measures are adding external cooling fan or power motor stop or slow down the operation. Motor in the high temperature operation, the coil insulation class with class B and class F or class H as well. At this time, not only the improvement of insulation level, bearing grease or permanent magnets will adopt measures to high temperature. 2, humidity decided to temperature and humidity, usually on the premise of no condensation. The main consideration of iron core and permanent magnet rust, corrosion, etc. Especially the HB type stepping motor under the condition of high temperature high humidity, the air gap between the stator and rotor must not appear rusty phenomenon. To improve the use environment, make its not more than environmental requirements prescribed by the manufacturer. If you have any special requirements shall be negotiated with the manufacturer. 3, dust dust mainly in conductive, bearings and other places, make its not personal foul by dust, mostly with protection coil parts such as rubber or resin, lead wire parts, bearings, etc. At this time should be negotiated with manufacturer. the main products: stepper motor, brushless motor, servo motor, stepping motor drive, brake motor, linear motor and other kinds of models of the stepper motor, welcome to inquire. Telephone:
