The ends of the ball screw processed can be installed on a fixed seat and brackets, brackets are unified these two. Put the bearing is ready to die. To match the ball screw rotation. Is installed on both ends of ball screw for taking fixed screw. Ball screw common support ways: 1, there are double bearing is fixed at one end, on the other side is the cantilever, most used in short stroke and vertical transmission. Double bearing 2, and one end fixed and the other end is a single bearing, the structure is simple, the only drawback is the single bearing end bearing rigidity. 3, there are double bearing is fixed at one end, on the other side is double bearing, a little bit complicated structure, but some are better than single bearing supporting rigid. 4, finally, there is double bearing fixed at one end, on the other side is double bearing, a little more complicated structure, but the axial rigidity teach better, high speed rotation is not easy to shake, especially for horizontal layout, especially the bidirectional loads with large span and large time. the main products: stepper motor, brushless motor, servo motor, stepping motor drive, brake motor, linear motor and other kinds of models of the stepper motor, welcome to inquire. Telephone:
