Introduces the linear guide rail pair has good bearing performance, linear guide has become a modern machine tools due to its positioning accuracy of a local, load-bearing characteristics, low conflict, screw. But almost no changes represented the ball screw machine in the use of a few decades ago for the first time. A common misconception is that the ball screw all necessary should be improved and the progress is leading accuracy. Consequently, ball screw, cannot think solitary to detain a elements, but affects the function of stepper circuit. In drawing up the size of the new linear guide, jena rotation skills, know to step into the function of the loop of the importance of ball screw, and depicts a ball screw, in order to satisfied request of modern machine tool control. Think one important element is reversed fault, (The course of reverse faults in the process of the lost package rotation direction change of ball screw significant), linear guide joint degrees can affect the workpiece positioning and appearance. Mechanical components in the system of the response to a serious of reverse fault influence. Novel depicts made a ball screw with low coefficient of conflict, but also adhere to the system of high rigid and eliminate reverse fault. Paints and materials, it also has to be able to cut the ball nut preloading, persist in rigidity. The accuracy of the ball screw livelihoods and wear also greatly progress; The ball screw is also very quiet, more traditional paints. Another advantage is the hot assembly due to cut the pre-installed, progress, stiffness and stability conflict coefficient is low, the yield and the occurrence of heat very low levels of ball screw. These improvements, made using the mixed materials, in the linear guide roller and ball nut in the configuration file change, change is not significant with blue/grey eyes the appearance of the ball screw, and cut pre-installed and super smooth running, can feel the ball nut trade open. The characteristics of the ball screw drive torque was only about a third of the sliding screw linear guide the ball rolls along the screw and nut, in order to obtain high efficiency. Compared with the sliding screw bag yesterday, entreaty for driving torque was only about a third. Therefore, not only can be reversed movement into linear motion, and can be linear motion into reverse movement. Nut of the selected type of nut ball screw nut, according to the cycle of ball way can be divided into: catheter type, circulator type, cover type. The 3 kinds of nut as shown below. Other, ball screw not only with ball circulation way classification, and on the basis of classification of preloading method. In the inside of the equipment of turning linear guide nuts such as ball screw/smooth spline of pulley, first the grease on the plate is placed in brackets. Smooth 0 in order to give full play to the function of the ball screw, must be based on all kinds of using conditions selected for smooth agent and smooth way. Smooth agent varieties, characteristics and smooth way to smooth local other accessories, please visit QZ smooth the choose and buy of equipment is greatly progress repair interval time attachment. Rust (Surface disposal, etc. )According to the using conditions such as environment, sometimes it is necessary to carry out ball screw rust disposal or use the raw material. If there are any dirt or foreign body intrusion, will accelerate wear, become the cause of the damage. Therefore, thinking to avoid dirt or foreign bodies (Cutting chip, etc. )Invasion, must choose dust equipment (Such as elastic cover, screw cap and health ring, etc. )In order to screw shaft protection up completely. the main products: stepper motor, brushless motor, servo motor, stepping motor drive, brake motor, linear motor and other kinds of models of the stepper motor, welcome to inquire. Telephone:
