Single spindle acceleration: a term used to describe a single feed shaft deceleration ability, square unit is mm/SEC. This index is determined by the physical properties of machine tool, such as the quality of the moving parts, the feed motor torque and drag, cutting load, etc. This value, the greater the cost in the process of movement in the process of acceleration and deceleration time is smaller, the higher the efficiency. Normally, for stepper motor, the value is between 100 ~ 500, step to progress into the motor system, can be set up between 400 ~ 1200. In the process of setting, began to set up a little bit small, running for a period of time, repeat a variety of typical movement, observe, if there is no abnormal situation, and then gradually increase. If it is found that abnormal situation, the lower the value, and keep insurance allowance of 50% ~ 100%. the main products: stepper motor, brushless motor, servo motor, stepping motor drive, brake motor, linear motor and other kinds of models of the stepper motor, welcome to inquire. Telephone:
