For some experienced people, when to use stepping actuators, will clear stepping actuators, before the relevant operation. Because only in this way, can ensure that the overall effect. Compare the link is through the comparison system of command signal feedback signal, so you can get the deviation signal. Under normal circumstances, is implemented by a special circuit and computer. Another is the controller, the corresponding part including the proportion, integral, and so on, the main task is to output error signal to element change, achieve the goal of control actuators. And step into the executive components and perform link, the link is that the main function of the requirements of the control signal, the various forms of energy can be input, is transformed into mechanical energy. And work through a drive control object, which can realize the function of the electromechanical integration. As well as controlled object, mainly including the control of the institution or unit, the main effect is that the purpose of a complete system directly. Under normal circumstances, including the traditional system, actuators, etc. And controlled object, mainly refers to the mechanical parameters, including the specific displacement, velocity, etc. Also should have specific testing link, is mainly refers to the proportion of output is measured and converted into a link needed for the device, usually, mainly including the sensors and conversion circuit, etc. Every link in the whole system is not independent, collaborative relationship between each other, so that the original can normal work. In the use of components, not only to clear step into the executive element, also to specific classification. According to the charged amount of different, can be divided into displacement, velocity and other systems. In addition to other systems, but also the corresponding temperature, specific humidity and other parameters. Classified according to the driving element types, stepping, pneumatic system can be divided into electric stepping system, etc. At the same time to step into the executive element classification, also should according to the specific control principle of classification. The stepping system can be divided into open loop and closed loop and half closed loop system. At the same time in the process of using, also equipped with displacement detection device, at the time of testing, relative location data, can timely feedback, and ensure the accuracy of measurement data. the main products: stepper motor, brushless motor, servo motor, stepping motor drive, brake motor, linear motor and other kinds of models of the stepper motor, welcome to inquire. Telephone:
